Built-in safeguards
MultiPillar checks orders before submission, records their outcomes and can pause new entries when a loss limit is breached or trading records need to be verified.
Based on the MultiPillar v3.1.2 MT5 source and its four release tester presets. Live settings can differ.
Before an order is sent
- Stops, pending prices and volume
- The router requires a stop loss before it can size a new trade. For pending orders, it checks the entry price against the current quote and checks stop-loss and take-profit distances against the broker’s published minimum. It rounds volume down to the broker’s lot step and skips the trade if that leaves less than the broker’s minimum.
- Market quote checks
- The four release tester presets enable a market-order filter with a five-second maximum quote age and a 30-point adverse price allowance. The router sizes against the adverse move to leave room in the risk budget. It refreshes the quote before submitting and rejects the entry if the price has moved too far against it. A separate spread limit is available and is off in the presets.
- Projected margin
- Before sending a market or pending order, the router estimates margin using current equity, used margin and the margin required for the proposed order. The presets block submissions if the estimate fails, free margin is insufficient, or projected margin level is below 150%. For pending orders this is an estimate at submission, and available margin can change before activation.
When MultiPillar pauses new entries
- Daily and weekly loss switches
- If enabled, breaching either configured equity loss threshold blocks new submissions and prompts a cancellation attempt for automated pending orders. Existing positions stay open. The daily reference uses broker server time and the weekly reference uses seven-day blocks from the start of the calendar year. The four release tester presets leave these switches off. Prop firms may use their own limits, calculation methods and reset times.
- Duplicate signals and uncertain fills
- Before asking the broker to place an order, MultiPillar saves a record of the signal. It uses that record to reject a second submission for the same signal. If an order is unresolved, the system pauses further entries across the strategies and checks the broker’s active orders, order history and position records. Some outcomes need manual review before trading can resume.
- Equity peak across restarts
- The release tester presets enable a saved equity high-water mark. MultiPillar checks redundant records so a restart or a damaged copy cannot silently reset drawdown to a lower peak. If the reference cannot be verified, the router blocks new entries. With pending-order cleanup enabled, the EA attempts to cancel its own pending orders while existing positions stay open. Live recovery requires a verified reference and explicit resumption.
- Prop Firm Ready starting balance
- MultiPillar verifies the saved starting balance before using it to size a new trade. If the records are missing or inconsistent after setup, new trade sizing stops until the reference can be verified. Existing positions can still be managed.
How Pillar 7 manages its trailing stops
For Volatility Expansion positions with trailing enabled, MultiPillar calculates a fresh stop from recent highs or lows and the market’s average true range. Before requesting a change it rechecks the open position, quote and broker stop distance. It only tightens an existing stop and carries forward the current take-profit level.
Checks run on chart ticks and, when enabled, on a one-second timer. The system defers stop changes during known market closures and rechecks the position and price when it retries. The broker controls when an update is accepted and where an order fills. Gaps and slippage can lead to losses beyond the planned stop.
← Back to Risk and Safety